 |
Now available the
Crafco Wide Hub Cutter. The new wide hub cutter produces a
cleaner cut, reduces spalling, eliminates wobble, reduces machine
vibration, and creates less pin wear. Now standard equipment on
all new Crafco Routers. Part Number 31145 |
|
 |
 |
31134 Steel Cutter Place in line with six spacers on each side. The cut will be approximately 1/2 inch wide. Use until needed depth cannot be reached any longer, then discard. Use on AC pavement or PCCP. Some spalling can be expected. |
 |
 |
31135
Wide Cut Cutters 31150 Extended Life wide Cut Cutter These cutters provide a cut width that can be adjusted from 1/2 inch to two inches. These cutters have no shoulders allowing a more exact cut width. All cutter blades must be evenly placed for proper balance and must have the proper number of spacers to keep cutters snug. Use on AC pavement or PCCP. Some spalling can be expected. |
 |
 |
31136
Carbide Cutter 31149 Extended Life Cutter Place six spacers on each side for a 1/2 inch wide cut. Stack two cutters side by side with three spacers on each side, or stagger in a 2-1-2-1-2-1 configuration for a 1.3 inch wide cut. You can also use three cutters side-by-side for a two inch wide cut. Always stack or stagger in a balanced manner. These cutters can be used on AC pavement or PCCP. Some spalling can be expected. |
 |
 |
31138 6 1/2" Carbide Cutter These cutters are the same as the 31136 cutter except they have an increased cut depth up to two inches. Three cutters are evenly spaced on the cutter head leaving every other pin empty. |
